Mrv-communications LX-4000 Series Uživatelský manuál stáhnout pdf (Strana 20)

Installing the LX-4000 Series

MRV Communications, Inc. www.mrv.com 451-0308

• The unit may be front, rear, or center mounted.

• There is no mounting difference between the 19” and 23” rack mount ears.

Mounting the Unit into a 19-inch or 23-inch Rack

Attach the brackets to the unit, and then mount the unit in the rack. Refer to Figure 12 for further

information.

Figure 12 - Mounting an LX-4000 Series in Rack

Cable Connections

This section explains the cable connections for the LX-4000 unit.

Connect the Power Cable

Connect the supplied power cable to the rear of the LX-4000 unit and plug the other end into a 3-

prong wall outlet.

Connecting the Ethernet Interface

NOTE: This port is set to auto negotiation by default. You can manually configure the port speed

and duplex if you want. Refer to the LX-Series Commands Reference Guide for further

details.

The three bottom side screws hold

the cover on the unit. To front-mount

the unit, you must

attaching the rack-mount brackets.

Then insert the supplied screws through

the brackets and into the same holes.

remove the front

and center top and bottom screws before

If you reverse-mount

the unit, remove the rear

and center top and bottom

screws, and insert the

supplied screws through

the rack-mount ears.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 64 65

Žádné komentáře

Mrv-communications LX-4000 Series Uživatelský manuál Strana 20