MRV Communications LX-4000 Series Technické informace stáhnout pdf (Strana 195)

100

101

Configuring IP Interfaces

Setting Maximum Telnet Connections 6-15

X To verify that a rotary has been disabled

Execute the monitor/show interface rotary command. If

the rotary is actually disabled, it will say in the Rotary State

column of the screen will show as Disabled.

For more information about the monitor/show interface

rotary command, see “To display rotary information for an IP

interface” on page 6-19.

Setting Maximum Telnet Connections

Use this command to limit the number of open connections on

the telnet port per interface. When the maximum count is

reached, the LX stops listening on the socket. When one of the

connections is closed, the LX starts listening again. The range is

from 0 - 32. The default is 0 (unlimited connections).

X To configure telnet max connections

Execute the telnet max connections command in

Interface command mode. In the following example, the

command sets the maximum connections to its highest

number:

Example Intf 1-1:0 >>telnet max connections 32

Displaying Interface Information

This section describes how to display information about IP

interfaces and rotaries. The IP interface information includes

characteristics, port mapping, statuses, and summaries. The

rotary information includes the Rotary IP Address, the Rotary

ports, the Rotary type, and the Rotary State.

X To display the characteristics of an IP interface

Use the monitor/show interface characteristics

command. In the following example, the interface

characteristics are displayed for IP interface 1:

Example Intf 1-1:0 >>show interface 1 characteristics

1 2 ... 190 191 192 193 194 195 196 197 198 199 200 ... 691 692

Komentáře k této Příručce

Žádné komentáře

MRV Communications LX-4000 Series Technické informace Strana 195

Komentáře k této Příručce

Související produkty a manuály pro Servery MRV Communications LX-4000 Series