MRV Communications LX-4000 Series Technické informace Strana 475

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 692
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 474
Configuring Redundant Ethernet
Bonding Link 17-5
Bonding Link
This command monitors the physical link of the primary
ethernet port if it goes down and the secondary ethernet port
comes up. When the secondary ethernet port comes up, the Mac
address and the IP address are shifted to the secondary link.
X To monitor the link by the physical connection, and to
send a poll every second
Use the following command syntax:
Syntax Intf:1-1>> bonding link <number_of_milliseconds>
Example Intf:1-1>> bonding link 1000
Bonding Link ARP Address
This command monitors the primary link via ARP to a defined
address on the network. ARP is used to generate traffic and
receive a response, so the primary link will receive traffic in case
no other network traffic is present. If the ARP target fails to
respond, the primary link will only fail over if no traffic is
received within twice the length of the ARP interval. The
redundant link assumes the primary role. The MAC and IP
addresses are shifted to the redundant link.
X To monitor the link integrity using ARP
Use the bonding link arp address command. If the
ARP fails, the link is presumed to be down and the LX will
switch over to the redundant link. Use the following
command syntax:
Syntax Intf:1-1>> bonding link arp address <A.B.C.D>
Example Intf:1-1>> bonding link arp address 119.255.255.255
Zobrazit stránku 474
1 2 ... 470 471 472 473 474 475 476 477 478 479 480 ... 691 692

Komentáře k této Příručce

Žádné komentáře