MRV Communications LX-4000 Series Technické informace stáhnout pdf (Strana 412)

100

101

15-24 Using the Analog Input Commands

LX Series Configuration Guide

Using the Analog Input Commands

This section explains how to configure the analog input

commands, including the following:

 Naming Analog Inputs

 Configuring an Analog Input Description String

 Defaulting the Description for an Analog Input

 Resetting Analog Inputs to the Defaults

 Resetting the Analog Input Name to Its Default

 Enabling and Disabling the Analog State

 Configuring Analog Calibration

Naming Analog Inputs

The default name for an analog input is canonically derived from

the port number, slot number and point number. For example,

the default name for the 8th analog input on the 2nd slot of the

HDAM being managed by port 5 is

5_2_8.

X To configure by default name or by physical location

on the HDAM

Use the following command syntax:

Syntax hdam analog <analog_name> name <new_name>

X To configure a descriptive name for any analog input

in the LX-7204T/7304T

Use the following Privileged command syntax:

Syntax hdam analog port <port_number> slot <slot_number> point

point_number> name <new_name>

where

You can use

each point

name after on

the LX. You

can’t use the

same name on

multiple ports,

slots, or points.

analog_name Name of the analog input to rename.

new_name New analog name to assign to the analog input. The

name must start with a letter, and the remainder of the

name can contain only letters and/or numbers and/or

underscores.

1 2 ... 407 408 409 410 411 412 413 414 415 416 417 ... 691 692

Komentáře k této Příručce

Žádné komentáře

MRV Communications LX-4000 Series Technické informace Strana 412

Komentáře k této Příručce

Související produkty a manuály pro Servery MRV Communications LX-4000 Series